|
|
 |
|
|
Join the Discussion |
"I noticed the front left
axle shaft was loose - it moved up and down the axle arm - while the right side
didn't move at all. "
TRUCHA1 |
| |
|
| |
|
NOTE:
All torque specs are either from the 1973 Ford Truck shop
manual or from a ’73-’79 Haynes Ford Pickup & Bronco manual, unless
otherwise noted. You may want to double check the torque specs for your year.
Removal/Installation Procedure
Previous Step | Step 9
|
Next Step
9. Before you can install the hub/rotor assembly you have to install the inner wheel bearing and seal (I think it’s called the
inner wheel bearing seal) listed above, part #012035. If you get the same hub/rotor assembly as I did you’ll notice that both the
inner and outer bearing races are already installed. So you will end up with four extra bearing races. Be sure and grease the
bearings good before you install them. The inner wheel bearing seal is a bit of a pain to install. I covered the seal (metal and
rubber) with a grease rag and lightly hit it with a hammer and a 6” socket extension until it was tightly seated.
Previous Step | Step 9
|
Next Step
|
